Control Kits

Required to Operate
SWG/CV Power Venters

Control Kits (CK) control the operation of SWG/CV Power Venters. See the chart below to select the proper kit for your application. Control Kits can also control the operation of Field Draft Inducers.

Selecting the proper Control Kit for your application
Model Draft Proving Switch Gas Pressure Switch Secondary Safety Switch Thermal Post Purge Adjustable Electronic Post Purge Fixed Post Purge Draft Control RJR-6
Oil
CK-61 All oil-fired systems.
Has adjustable electronic post purge.		 • • • •
CK-62 All oil-fired systems. Has thermally activated post purge. • • • •
CK-63 All oil-fired systems. (May require optional delay oil valve for simultaneous burner operation.) • • •
Gas - 30 mv
CK-20FV
CK-20FG		 30 millivolt gas-fired water heaters and gas-fired pool or spa heaters with a manual or internally mounted thermostat. • • •
CK-21 Gas-fired instantaneous water heaters with pressure tap port in the burner manifold. • •
Gas - 24 v
CK-41F
CK-41P**		 Furnaces, boilers, unit heaters and water heaters operating with a 24 VAC gas valve without factory mounted spillage switches. • • •
CK-43 Draft induced 24 VAC gas valve systems. Includes a 4" MG-1 draft control and post purge. • • •
Gas - 750 mv
CK-81*** 750 millivolt operated boilers, furnaces, water heaters, pool or spa heaters and gas-fired fireplaces when operated with a remote mounted thermostat or on/off switch. Operated off a 24 VAC circuit. • •
Gas - Co-venting Multiple Appliances
CK-91FV
CK-91FG		 Gas-fired draft induced 24 VAC gas valve systems and a 30 millivolt operated water heater. Includes a 4" MG-1 draft control and post purge. • • • • •
CK-92FV
CK-92FG
CK-92FVP**
CK-92FGP**		 Gas-fired furnace or boiler and a 30 millivolt operated water heater. Includes post purge. • • • •
* Control Kits are ETL approved accessories when used in conjunction with the SWG Power Venter. ** Plugs into 24v electric damper *** A secondary safety switch should be used with a CK-81 F = Fixed Post Purge FV= right hand threaded TCA Safety Switch FG= left hand threaded TCA Safety Switch

Control Kit Installation

CK-41 CK-63
CK-41F mounted at venter. For use with a 24 VAC, gas-fired system (shown with cover off).

CK-63 remote mounted. For use with 120 VAC oil-fired systems. Electronic post purge is included (shown with cover off).
contractorsidemenu